Floor Socket Barrier

Extrait du fichier (au format texte) :

Instructions - Floor Socket Barrier

Barriers are supplied in packs of two, complete with an Allen key for assembly.
1. Mark out the position of the sockets. Normal spacing is approx' 2.5mtrs between posts,
but this can be increased to 3mtrs on occasion, so long as the tension on the cord is sufficient to maintain a straight and level line.
2. Drill the holes in the floor surface using an appropriate masonry drill to produce a clean lipped hole 28mm to 30mm dia' and approx' 73mm deep and clear the hole of any dust or debris.
3. Tighten each upright firmly into its socket.
4. To get the best from this equipment we recommend installing the sockets with the uprights inserted to ensure the cord slots at the top of the post are correctly aligned.
5. Apply an epoxy resin to the base and sides of the hole and insert the socket, being sure to bed it down' by using small backwards and forwards rotational motions to assist the movement of the resin.
6. If required carefully apply additional resin to any gap at the top of the socket to ensure that the finish is flush with the floor and clean off any excess resin that squeezes out.
7. Use a spirit level to check that the upright it is absolutely vertical, and if necessary support in this position whilst the resin cures.
Then, when the resin is cured, for PPC barriers, follow these guidelines...
8. Remove the top caps using your finger or a small screwdriver and tie a simple granny'
knot in the end of the elasticated cord. Pull it very tight and cut off any excess cord close to the knot.
9. Push the knot into the recess in the top of the upright with the cord exiting through one of the slots and replace the cap.
10. Pull the cord tight to the next barrier with enough tension to make a straight line and push into the slots: straight across if it is a straight line or at right angles if it is at a corner.
11. Repeat step 9 for the last barrier or use a wall terminator.
Note: In an installation where the object is completely surrounded, instead of two separate knots tie the two ends together with a reef knot, pull very tight and cut off the ends. If required, cut off one of the cap legs to accommodate the size of this knot.
A line of barriers can also end with the cord returning to the wall by using a wall terminator.

Dans la boutique



Floor Socket Barrier
Floor Socket Barrier
26/08/2024 - www.absoluteproduct.com
Instructions - Floor Socket Barrier Barriers are supplied in packs of two, complete with an Allen key for assembly. 1. Mark out the position of the sockets. Normal spacing is approx' 2.5mtrs between posts, but this can be increased to 3mtrs on occasion, so long as the tension on the cord is sufficient to maintain a straight and level line. 2. Drill the holes in the floor surface using an appropriate masonry drill to produce a clean lipped hole 28mm to 30mm dia' and approx' 73mm deep and clear the...

Absolute Art Hanging Track Explainer
Absolute Art Hanging Track Explainer
26/08/2024 - www.absoluteproduct.com
A RT H A NG I N G TRAC K EXP LA INED ST E P 1: A SSE SSIN G T HE INSTAL L AT ION S ETTING Before you can select a track (rail), you need a clear picture of the installation setting. You can use Important: No matter the material strength of the art hanging track, it must rely on the structure of the below as a checklist and send it back to us for tailored advice, or you can compare your list to the wall to stay in place. To safeguard valuable artworks, know what's in the wall or ceiling. the...
 

Spectrum Baroque
Spectrum Baroque
13/06/2011 - www.lasry.fr
SPECTRUM BAROQUE & Co APPLICATIONS POSSIBILITES DE TRANSFORMATION : VOIR LEGENDE BR Amethyst BR Burgundi BR Champagne BR Cinnamon BR Clear BR Jade BR Pale Gray BR Steel Blue BR Teal Sept 08 Applications Artistiques : Fusing, Vitraux, etc... Fiche N° 4.5 En raison de la reproduction et de l'impression, les couleurs peuvent différer des couleurs originales. Elle ne sont là qu'à titre indicatif Ep : 3 a 4 mm Dim : 122 x 61 cm Caisse : 50 feuil ou 37 m² BR 130.8 BR 308 BR 400 BR...

TOPAZE GBi 26 mm
TOPAZE GBi 26 mm
13/02/2012 - www.technal.fr
04/10 02 - 4.11 - Coupes (échelle 1/3) : 200 Elastomère 1ère catégorie sur fond de joint Patte de fixation en acier Elastomère 1ère catégorie sur fond de joint Patte de fixation en acier Elastomère 1ère catégorie sur fond de joint Coupe verticale Coupe horizontale les fenêtres Topaze : pose en rénovation (GBi 26 mm)

Acome Rapport DD 2007 AN bd
Acome Rapport DD 2007 AN bd
25/11/2010 - www.acome.fr
ACOME 2007 Solutions for a sustainable world Sustainable development report for 2007 Solutions for a connected world GROUP PROFILE One Workers' Production Cooperative in the world ACOME, a Workers' Production Cooperative, is part of the so-called social economy sector. Breakdown of turnover among stakeholders Breakdown of the TO by Markets TELECOMMUNICATIONS NETWORKS AUTOMOBILE ­ 359 M C SUPPLIERS Purchase of Raw materials, Consumables, Services... TRANSPORT AND ENERGY NETWORKS CONSTRUCTION...

Alkern : un large ?ventail de solutions d?di?es ? l'am?nagement urbain qui s'enrichit cette ann?e encore
Alkern : un large ?ventail de solutions d?di?es ? l'am?nagement urbain qui s'enrichit cette ann?e encore
22/04/2025 - www.n-schilling.com
Résumé en cours de création pour ce fichier PDF

NotCTU25-115
NotCTU25-115
09/04/2011 - www.jetto.fr
Les aérothermes CTU Manuel de mise en route et d'opérations d'entretien SECTION 1: SECURITE DE L'APPAREIL DE CHAUFFAGE Votre sécurité est importante pour nous ! 2.1 Les Distances de Dégagement par Rapport Ce symbole est utilisé dans ce manuel aux Matériaux Combustibles pour vous prévenir d'un éventuel Les distances de dégagement par rapport aux incendie, un danger électrique ou des matériaux combustibles doivent être maintenues risques de brûlures. Prière de faire dans tous les...

terre et confort interieur
terre et confort interieur
09/04/2011 - www.akterre.com
Premières assises nationales de la construction en terre Grenoble, 5 avril 2008 TERRE ET CONFORT INTÉRIEUR - L`ÉQUILIBRE IN BALANCE ­ LEHM UND RAUMKLIMA DR.-ING. CHRISTOF ZIEGERT ZRS Architekten Ingenieure, Berlin _ INTRODUCTION 1 EINFÜHRUNG MATÉRIAU BAUSTOFF VALEURS MATÉRIAU WERTE BAUSTOFF VALEURS CLIMAT INTÉRIEUR WERTE RAUMKLIMA DR.-ING. CHRISTOF ZIEGERT _ _ _ EINLEITUNG MATERIAL / TECHNIK OBERFLÄCHE KONSTRUKTION / PROJEKTE DR.-ING. CHRISTOF ZIEGERT _ EINLEITUNG MATERIAL...